Material: Steel.

• For fixing a hub (e.g. drive wheel, rotor or similar) on a shaft.
• For low torques.
• Very short version.
• Also suitable for small hub diameters.
• Not self-centering.
• Not self-locking.
• Axial movement during mounting.

Fit: Shaft h8, Hub H8. Surface roughness hub/shaft max. 12,5 µm.

Material: Stainless steel 1.4401 (SS316).

Clamping bush for lower torques; not self-centering.

Fit: Shaft h8, Hub H8.

Mounting: Slightly oil the clamping set before mounting, do not
use molibdenum disulphide or grease. Tighten the screws evenly and
crosswise in several steps. Demounting: Due to the cone angle,
the clamping set is usually released once all screws have been fully
unfastened. There a three large threads cut into the front ring, which
serve to remove this ring.

Ts – Fastening Torque

T – Transmittable Torque

F – Transmittable Axial Force

P – Surface Pressure onto Hub

### new sizes 14 – 19 mm ###