Material: Steel.

• For fixing a hub (e.g. drive wheel, rotor or similar) on a shaft.
• For low torques.
• Very short version.
• Also suitable for small hub diameters.
• Not self-centering.
• Not self-locking.
• Axial movement during mounting.

Fit: Shaft h8, Hub H8. Surface roughness hub/shaft max. 12,5 µm.

Material: Steel. Clamping bush for medium high torques; not
self-centering.

Fit: Shaft h8. Hub H8.

Mounting: Slightly oil the clamping set before mounting, do not
use molibdenum disulphide or grease. Tighten the screws evenly and
crosswise in several steps.

Demounting: Due to the large cone angle, the clamping set
releases on its own after the screws have been fully unfastened.

There are three larger threads cut into the front ring, which serve to
remove this ring.

Ts – Fastening Torque

T – Transmittable Torque

F – Transmittable Axial Force

P – Surface Pressure onto Hub

### New sizes 14 to 18 mm ###