Material: Zinc die-cast ZnAI4Cu1.

Shaft angle = 90°. Bores machined. The bevel gears only run as a pair at
the stated ratio. In the torque calculation of zinc-die-cast bevel gears
only the root strength was considered. Due to the material properties
these gears are only to a limited extend suitable for continuous
operation. Note for ordering: These gears are sold singulary, not
by pair. For a pair of bevel gears, you have to order two matching gears
of the same module and ratio. At ratio 1:1, you need two pieces of the
same number of teeth. At ratio uneven 1:1, you need two pieces with a
different number of teeth of the same ratio.